This project is a submission for the Shape Your UNIHIKER: Creative Case Design Challenge by DFRobot. The Case was designed on Fusion 360 and its features are tailored for 3D printing.
It comprises of four parts:
1. The Main Case: This is the part that protects the back and sides of the UNIHIKER. It is equipped with well-sized holes for each of the ports and buttons on the sides of the UNIHIKER.
2. The Bottom Cover: This is the part that covers and protects the bottom of the UNIHIKER just above the UNIHIKER connector. It makes use of a snap-fit mechanism to firmly connect to the Main Case and for easy removal.
3. The Connector Protector: This is the part that can slide on tightly and firmly unto the UNIHIKER bottom connector when it is not in use.
4. The Stand Mechanism: designed to ensure simplicity and efficiency. It is attachable to the back of the Main Case and is also detachable for when not in use. It serves to incline the UNIHIKER at a suitable angle whenever it may be intended e.g., during charging, display, or work. The .step source file is attached
UNIHIKER CASING FUSION 360.zip 
