Unihiker K10 3D Printed Case

I'm working on a project with my Unihiker K10 that has a custom enclosure around it. As such I needed to get the dimensions down for the device itself. Sharing the models here if it's of any use to anyone else. I printed these with PETG and only used supports for the bottom component as the buttons needed it.

This case closes with a snap setup where each corner has a small cutout on the cover and the bottom has slightly smaller edges which align. It's not the most ideal setup as it will likely wear in time but if you're not opening the case often it does the job and avoids the need to add bulk to fit screws. My subsequent case for my project will use screws but it'll have extra bulk as well while this is more of a cheap protection case.

The screen itself sits mostly flush with the case. The sensors at the top are visible through a cutout in the case.

I've created a cutout for the LEDs, the camera, and several small cutouts for the speaker.

Additionally I have cutouts on the sides for the battery, the various connectors, and I designed the part that covers the button so they are pressable to trigger the button.

icon K10Case.zip 26KB Download(0)

09/02/25 - Initial case

09/03/25 - Updated the K10Case to better fit and adjusted the buttons so no support is needed any further

License
All Rights
Reserved
licensBg
0